No products in the cart.

  • Handheld PID / Model PGM-7320

    Honeywell MiniRAE 3000+

    Portable handheld VOC monitor

    A comprehensive handheld VOC monitor built on third-generation patented PID technology, made to measure one of the highest levels of ionizable chemicals available on the market. Full-range measurement from 0 to 15,000 ppm of VOCs, in a 26 oz (738 g) instrument.

    15,000 ppmTop of VOC range
    <3 sResponse time T90
    16 hoursOf operation
    6 monthsDatalog at 1-min intervals
    Honeywell MiniRAE 3000+ handheld VOC monitor with flexible probe
    Flex-I-Probe™Included
    Lamp & sensorEasy access
    Graphic display4 lines, LED backlight
    FlashlightIntegrated, own key
    Rubber bootDurable, bright yellow
    Measurement range

    Zero to 15,000 ppm on one sensor

    The MiniRAE 3000+ reads VOCs across two bands. Below 1,000 ppm it resolves to a tenth of a ppm; from 1,000 to 15,000 ppm it resolves to 1 ppm. The T90 response time is under 3 seconds in both.

    Band 01

    0 to 999.9 ppm

    Resolution
    0.1 ppm
    T90
    <3 s
    Band 02

    1,000 to 15,000 ppm

    Resolution
    1 ppm
    T90
    <3 s
    On screen

    Direct readout

    • Instantaneous reading
    • VOCs as ppm by volume (mg/m³)
    • High values
    • STEL and TWA
    • Battery and shutdown voltage
    • Date, time, temperature
    Accuracy

    Compensated & calibrated

    Humidity compensation with built-in humidity and temperature sensors.

    Two-point or three-point calibration for zero and span, with calibration memory for 8 calibration gases, alarm limits, span values and calibration dates.

    Lamp: photoionization sensor with a standard 10.6 eV lamp.

    The plus

    BLE, an app, and a radio

    A BLE module and dedicated app for enhanced datalogging. Download data and upload instrument set-up through the app, or from a PC through the charging cradle. A built-in RF modem carries readings further.

    • BLE module + dedicated appEnhanced datalogging

      Up to 15ft (5m) for BLE
    • ProRAE Guardian & RAELink3 MeshTypical, line of sight

      LOS > 330 ft (100 m)
    • ProRAE Guardian & RAEMesh ReaderTypical, line of sight

      LOS > 660 ft (200 m)
    • EchoView HostTypical, line of sight

      LOS > 660 ft (200 m)
    • Command centerVia RAELink 3 modem or Mesh

      Realtime data connectivity with the command center located up to 2 miles (3 km) away, through a Bluetooth connection to a RAELink 3 portable modem or optionally via Mesh Network

    Typical wireless range · LOS = line of sight · bars not to scale. Receivers and modems are not part of the monitor-only package.

    BLE module & dedicated app

    Download data and upload instrument set-up using the BLE module and dedicated app, for enhanced datalogging capability.

    Six-month datalogging

    Standard 6 months at one-minute intervals, with ProRAE Studio II Package.

    Built-in RF modem

    Wireless data transmission on the ISM license-free band, IEEE 802.15.4 Sub 1GHz, into the Mesh RAE Systems dedicated wireless network. Radio module supports BLE or Bluetooth or RM900.

    Low maintenance

    Lamp and sensor, within easy reach

    Low maintenance, easy access to lamp and sensor, low cost of ownership. A lamp-cleaning kit and a tool kit ship with the monitor.

    Sensor-end components of a MiniRAE handheld PID: lamp, sensor block and inlet cap
    MiniRAE PID sensor end · inlet cap, lamp, sensor block
    • 01

      Easy access to lamp and sensor

      Lamp and sensor are designed for easy access. The lamp-cleaning kit and tool kit are part of the monitor package.

    • 02

      3-year 10.6 eV lamp warranty

      Warranty: 3 years for 10.6 eV lamp, 1 year for pump, battery, sensor and instrument.

    • 03

      Field-replaceable power

      Rechargeable, external field-replaceable Lithium-Ion battery pack: 16 hours of operation (12 hours with the included alkaline battery adapter).

    • 04

      A pump that protects itself

      Internal, integrated pump at 500 cc/min that samples from 100’ (30m) horizontally or vertically. Auto pump shutoff at low-flow condition, plus a diagnostic alarm and display message for pump stall.

    In the case

    Monitor only includes

    • MiniRAE 3000+ Monitor, Model PGM-7320
    • Wireless communication module built in, as specified
    • Datalogging with ProRAE Studio II Package
    • Charging/download adapter
    • RAE UV lamp, as specified
    • Flex-I-Probe™
    • External filter
    • Rubber boot
    • Alkaline battery adapter
    • Lamp-cleaning kit
    • Tool kit
    • Soft leather case
    MiniRAE 3000+ with flexible probe and external filter
    Consumable · Replacement

    Inlet probe filter

    External filters (pack of 5). An external filter is supplied with the monitor.

    Part 002-3022-005
    View filters
    Responder in a hazmat suit sampling vapor at a rail line with a MiniRAE 3000+
    Workers can quickly measure VOCs and wirelessly transmit data
    Applications
    • Oil and Gas
    • HazMat
    • Industrial Safety
    • Civil Defense
    • Environmental and Indoor Air Quality
    Alarms

    Count the flashes, know the limit

    A 95dB at 12” (30 cm) buzzer and flashing red LED indicate exceeded preset limits. The cadence tells you which one.

    High

    3 beeps and flashes per second

    3per second

    Low

    2 beeps and flashes per second

    2per second

    STEL and TWA

    1 beep and flash per second

    1per second
    • Alarms latching with manual override or automatic reset.
    • Additional diagnostic alarm and display message for low battery and pump stall.
    US & Canada · CSAClass I, Division 1, Groups A, B, C, D

    Classified as Intrinsically Safe.

    Europe · ATEXII 2G EEx ia IIC T4
    IP ratingIP-65 unit running

    IP-67 unit off and without flexible probe.

    Operating-4° to 122° F

    (-20° to 50° C) · 0% to 95% relative humidity (non-condensing).

    Specifications

    Key specifications

    Download the datasheet below for the full document.

    SensorsPhotoionization sensor with standard 10.6 eV lamp
    Gas monitor · VOCs
    Range0 to 999.9 ppm · resolution 0.1 ppm · response time T90 <3 s
    Range1,000 to 15,000 ppm · resolution 1 ppm · response time T90 <3 s
    Calibration & compensation
    CalibrationTwo-point or three-point calibration for zero and span.
    Calibration memoryCalibration memory for 8 calibration gases, alarm limits, span values and calibration dates
    Humidity compensationHumidity compensation with built-in humidity and temperature sensors
    Physical
    Size10” L x 3.0” W x 2.5” H (25.5 cm x 7.6 cm x 6.4 cm)
    Weight26 oz (738 g)
    AttachmentsDurable bright yellow rubber boot
    IP rating
    • IP-67 unit off and without flexible probe
    • IP-65 unit running
    Interface
    Display graphic4 lines, 28 x 43 mm, with LED backlight for enhanced display readability
    Keypad1 operation and 2 programming keys, 1 flashlight on/off
    Direct readout
    • Instantaneous reading
    • VOCs as ppm by volume (mg/m³)
    • High values
    • STEL and TWA
    • Battery and shutdown voltage
    • Date, time, temperature
    Sampling
    Sampling pumpInternal, integrated flow rate at 500 cc/min · Sample from 100’ (30m) horizontally or vertically
    Low flow alarmAuto pump shutoff at low-flow condition
    Environment
    Temperature-4° to 122° F (-20° to 50° C)
    Humidity0% to 95% relative humidity (non-condensing)
    Power
    Battery
    • Rechargeable, external field-replaceable Lithium-Ion battery pack
    • Alkaline battery adapter
    Running time16 hours of operation (12 hours with alkaline battery adapter)
    Alarms
    Alarms95dB at 12” (30 cm) buzzer and flashing red LED to indicate exceeded preset limits
    Alarm cadence
    • High: 3 beeps and flashes per second
    • Low: 2 beeps and flashes per second
    • STEL and TWA: 1 beep and flash per second
    LatchingAlarms latching with manual override or automatic reset
    DiagnosticsAdditional diagnostic alarm and display message for low battery and pump stall
    Data
    DataloggingStandard 6 months at one-minute intervals
    Communication & data download
    • Download data and upload instrument set-up from PC through charging cradle or using BLE module and dedicated APP
    • Wireless data transmission through built-in RF modem
    Wireless
    Wireless networkMesh RAE Systems Dedicated Wireless Network
    Wireless range (typical)
    • Up to 15ft (5m) for BLE
    • EchoView Host: LOS > 660 ft (200 m)
    • ProRAE Guardian & RAEMesh Reader: LOS > 660 ft (200 m)
    • ProRAE Guardian & RAELink3 Mesh: LOS > 330 ft (100 m)
    Wireless frequencyISM license-free band. IEEE 802.15.4 Sub 1GHz
    Radio moduleSupports BLE or Bluetooth or RM900
    Wireless approvalsFCC Part 15
    Safety certifications
    US and CanadaCSA, Classified as Intrinsically Safe for use in Class I, Division 1, Groups A, B, C, D
    EuropeATEX II 2G EEx ia IIC T4
    Warranty
    Warranty3 years for 10.6 eV lamp, 1 year for pump, battery, sensor and instrument
    Resources & service

    Datasheet, warranty & repair

    The MiniRAE 3000+ datasheet and FarrWest, a Honeywell Authorized Service Provider for BW and RAE Systems gas detection.

    Manufacturer warranty: 3 years for 10.6 eV lamp, 1 year for pump, battery, sensor and instrument.

    FAQ

    Questions, answered

    What concentration range does the MiniRAE 3000+ cover?
    Full-range measurement from 0 to 15,000 ppm of VOCs. From 0 to 999.9 ppm the resolution is 0.1 ppm; from 1,000 to 15,000 ppm it is 1 ppm. Response time (T90) is <3 s in both bands.
    What wireless and data options does it have?
    The MiniRAE 3000+ has a BLE module & dedicated APP for Enhanced Datalogging capability. You can download data and upload instrument set-up from a PC through the charging cradle, or using the BLE module and dedicated app. Typical BLE range is up to 15ft (5m).
    What is its ingress protection rating?
    It is rated IP-67 unit off and without flexible probe, and IP-65 unit running.
    Is it approved for hazardous locations?
    Yes. US and Canada: CSA, Classified as Intrinsically Safe for use in Class I, Division 1, Groups A, B, C, D. Europe: ATEX II 2G EEx ia IIC T4.
    How long does it run on a charge?
    16 hours of operation on the rechargeable, external field-replaceable Lithium-Ion battery pack, or 12 hours with the alkaline battery adapter, which is included.
    What lamp does it use, and how is it maintained?
    It ships with a RAE UV lamp as specified; the standard lamp is 10.6 eV. The design gives easy access to lamp and sensor, and a lamp-cleaning kit and tool kit are included with the monitor. The 10.6 eV lamp carries a 3-year warranty.
    How far can it sample from?
    The internal pump runs at 500 cc/min and samples from 100’ (30m) horizontally or vertically. The Flex-I-Probe™ and an external filter are included; replacement inlet probe filters come in packs of 5.
    Who services and calibrates it?
    FarrWest is a Honeywell Authorized Service Provider for BW and RAE Systems gas detection. The Repair Depot handles calibration, and covered warranty repair is described on Honeywell warranty service. Not every service level is available for every product, so call 210.566.1857 to confirm coverage for your model.
    Next step

    Put a MiniRAE 3000+ on your team

    Tell us what you monitor and where. We'll answer your questions on the MiniRAE 3000+, its package and spares, and send a quote.

    CONTACT US